Teka Repair

Identify the zone type and whether the others work; do not dismantle connections to test it.

Note when it began and whether cleaning preceded it. Do not keep attempting ignition if gas does not light.

Clean accessible parts according to the manual after cooling, without removing valves or safety devices.

They may share one appliance but each fault needs its own assessment. Identify the affected area when booking.

Record the mode names from the controls and the temperature used.

Note shelf position, cookware and whether results changed from previous use.

Follow the model’s cleaning programme rather than combining instructions from different ovens.

Do not remove it yourself. Describe the installation and any access difficulty when booking.

Describe visible ducting and any recent filter change without dismantling connections.

Note other controls and lighting; an unresponsive speed does not alone prove motor failure.

Check filter identification and care in the manual; grease and carbon filters do not necessarily share instructions.

It depends on the filter and model. Check its instructions before washing or replacing it with a similar-looking part.

Record the selected setting and whether the change was sudden; do not run the appliance empty for testing.

Stop use if the door or latch is damaged; do not bypass its safety switch.

Use cookware appropriate for the selected mode as stated in the manual and keep the door closure area clean.

Do not open the casing; internal parts may retain a dangerous charge after disconnection. Internal inspection requires a qualified technician.

Describe each compartment and any visible ice; inspection is needed and no particular board is proven faulty.

Identify where water appears and whether it returns after cleaning; do not insert tools into openings not covered by the manual.

Check that food and shelves do not obstruct closure, and follow the model’s ventilation clearances.

The symptom alone cannot identify the cause. Cooling, closure and controls need checking before refrigerant-circuit work is proposed.

Record the code and whether drainage began before stopping. Standing water alone does not prove pump failure.

Note the programme, load and whether water drained. Do not force the door or lid lock.

Follow the programme load and detergent guidance in the manual; never bypass the safety lock.

Not necessarily. Drainage, locking, programme conditions and inspection findings must be checked first.

Describe loading and whether results changed after a different detergent or programme.

Record any warning; do not tilt or pull out an integrated dishwasher to attempt draining.

Follow the loading arrangement, keep spray-arm paths clear and use dishwasher detergent.

A cleared warning alone does not confirm the cause is gone. For an anti-flood warning, stop use and follow the model guidance for inspection.

Describe the temperature setting, heater type and timing without opening the cover or altering connections.

Stop use and request inspection for leakage or repeated protective shutdowns; never bypass protection.

Follow the model manual for user care; leave gas, electrical and internal work to a qualified professional.

The code guides inspection using the model manual; it does not prove part failure. Do not use a heating-boiler or another brand’s table.